Minggu, 24 November 2013

04 Mazda RX-8 First Car?

automatic pool cleaner motor on ... Automatic Pool Cleaners - Swimming Pool Supplies & Parts at Aplus Pool
automatic pool cleaner motor image



Edgar


I'm thinking in getting an automatic 04 Mazda Rx-8 for my first car but I've read that it needs lots of maintenance and care but aside from that they have lots of issues. It has less than 35k miles on it and I think I can get it for 10 grand. Should I get it or look for other options.


Answer
I wouldn't usually recommend an RX8 as a "first car", but if you were to do so the automatic version would be the better choice as the 6 speed model is too powerful and twitchy for a novice driver. Way too many end up wrapped around a tree in the hands of novice drivers. The automatic version (especially the 04 & 05 models) have much less power and are more forgiving of a newbie driver learning the handling characteristics of rear-wheel drive. You can keep all your RSX's, Civics, and GTI's. They're all FWD and cannot EVER handle as well as a properly tuned RWD chassis.

Wankel Rotary engines do require some extra maintenance and care, but not a huge amount. More frequent oil changes (every 3000 miles/5000 KM) and Ignition component changes (plugs/wires/ign coils) are required.

Learning the "quirks" of the Rotary engine is required. Many of the reported problems you read about are from people who treat the RX8 as if it were just some everyday piston-driven car. It's not and it cannot be treated as such. A design limitation of the motor leaves it open to flooding much easier than a piston engine. If the motor is stopped while still running high-idle the excess fuel being pumped in can collect at the bottom of the rotor housings and thin or wash off the oil. This can results in loss of the seal between the housings and the apex seals on the rotors making the motor very difficult (or impossible) to start. There are a couple "de-flooding" procedures to learn or better yet prevent the issue from happening by ALWAYS letting the motor drop to low-idle (~900 RPM) before shutting it off. If it must be shut off cold you can rev up to 3000+ RPM and hold that for 10 seconds before shut down. This reduces fuel flow to "normal" while allowing any excess to burn off thus preventing flooding.

Another quirk is that the motor will build up carbon deposits easier. To prevent this you need to run the engine hard occasionally. Getting the motor up to red-line (while under load) frequently and when safe to do so really does a good job of this. "A Red-Line a Day will keep the Mechanic away" is a phrase every Rotary engine owner needs to know. A good, long highway run (6 - 8 hours) does this as well, so go for a long run on the occasional weekend. See the sights while cleaning your motor!

There is NO PROBLEM leaving an RX8 sitting for days at a time (contrary to C7S's post). I stored mine for 5 months every winter and for up to 2 weeks at a time while on business travel and NEVER had a problem starting my RX8 (which I owned for 5 years). You should disconnect the battery, though, if it's going to sit for more than 2 weeks as the electrical components will drain the battery. A weak battery CAN contribute to flooding because if it cannot start the motor the injected gas will pool as mentioned above.

One other note. 2004 was the first model year of the RX8 and as such did have more problems than later years (just like every new car). You will want to check to ensure all recalls were completed. There are some TSB's (technical service bulletins) that should be looked at as well. There was an upgraded starter TSB for the 04 & 05 models which spun faster and helped prevent flooding, for example.

Good luck on your decision. The RX8 is a great, fun car and there are a lot of owners that are quite passionate about this vehicle. Go check out the owners forum at:

http://www.rx8club.com

Over 300psi pressure in my Purex 3-cartridge pool filter blew cover off the canister.Filters were Clean. Why?




setonrock2


The pressure gage was pegged/stuck at 300psi. Previously under same conditions, i.e. clean filters, the pressure gage burst. This gage had a maximum of 60psi. On another occasion the 3/4" circulating lines that are about 2 feet below the pool water surface jettisoned water about 3 feet above the water surface for several seconds. Does anybody sell automatic (say 50 psi) pressure relief valves to prevent such dangerous operation? Can power disturbances-high voltage/frequency swings create such dangerous conditions? Being an electrical engineer I know that motor torque increases with increase with voltage and that motor speed increases with increase in frequency. These increases then can cause the pump to push more water through and if the water lines cannot handle the volume the result then could cause dangerous pressure to develop.


Answer
You must have some form of restriction in the outlet from the cartridge canister to cause such a pressure build up. Check that there is nothing floating around loose that could block the outlet. Are the outlet hoses flexible or rigid, sometimes the inner lining of a flexible hos can separate and block the hose. The idea that power frequency fluctuations would speed the motor up can be ruled out as if the frequency fluctuated enought to cause that to happen the Power Station Generators/transformers etc would all have tripped way before it could happen.




Powered by Yahoo! Answers

Are there online instructions for swimming pool maintenance?

automatic pool cleaners online on Aquabot Turbo T Automatic Pool Cleaner ABTRT
automatic pool cleaners online image



caroll





Answer
I use an Aqualux system. For the last three years I have done nothing but keep the pH level balanced. Very easy.

http://users.iafrica.com/a/am/amos/aqualux.htm

(From the site)
Finally a few tips for effective pool care:

Dust, leaves and debris blown in by the wind quickly spoil the look of a pool, while the suntan oils, make-up, sweat from the constant use of swimmers escaping the heat, also mar the purity of the water.

Firstly, clean all the leaves and debris out of the leaf traps both in the weir and the sludge trap, because if water cannot flow to the filter, it cannot be filtered.

Do a good backwash. To get the filter reasonably clean one must backwash for at least 3 minutes followed by a 1 minute rinse. If backwash was not done for a couple of weeks, repeat this process twice.

The next step is to carry out the necessary water tests and correct pH if necessary. It is important to remember that correctly balanced water creates an unfavourable environment for bacteria to grow in.

Next, water level. The water level of the pool should be checked regularly. Dirt and leaves will not skim off into the weir if the level is not correct. If the water level sinks more rapidly than experienced with normal evaporation the pool floor and walls should be checked for cracks.

If an automatic pool cleaner is used it should not run continuously. It is just a water vacuum cleaner and therefore should only be used when the floor and the walls of the pool are dirty. The top 25cm (approx. 10 inches) of water is the area where bacteria flourishes and this water will not be filtered if the
cleaner is continuously in use.

Leaves and debris, not skimmed automatically because the pool cleaner is in constant use, become waterlogged and drop to the floor of the pool. Most pool cleaners have a pulverising action and when the debris is sucked up it becomes a sludge which dirties the filter sand much more quickly.

It is essential to run the filter for at least eight hours every day.

With an automatic pool cleaner this should be increased to twelve hours because of the restricted water flow through the pool cleaner and hoses.

Automatic in ground pool vacuum?




Jessica Ra


Hello everyone,

I was wondering which automatic in ground pool vacuum is good for cleaning?

I am looking for something cheap and reliable, anyone have any experience with some good vacuum cleaners which does the job.

Thanks,
Jessica



Answer
i own a pool company and your better automatic pool vaccums would be either a polaris or a creepy crawly but you can get them cheaper online then in a pool store. look under pool companies




Powered by Yahoo! Answers