Tampilkan postingan dengan label automatic pool cleaner problems. Tampilkan semua postingan
Tampilkan postingan dengan label automatic pool cleaner problems. Tampilkan semua postingan

Minggu, 04 Mei 2014

Tail on Pentair Legend Pool Cleaner is shooting water all over whenever it makes a turn.?




Kimm


I have a Pentair Legend Pool cleaner. The tail constantly whips out of the water whenever it makes a turn and shoots water everywhere. It didn't used to do it so I know that something is not right. I'm tired of cleaning my windows :) Any ideas?


Answer
Two things to try:

1)There should be adjustment screw near tail attatchment point that controls the strength of tail water jet

2)there is a tail weight available from polaris pool cleaner tyhat will also fit on legend

more tips here: http://www.swimming-pool-information.com/automatic-pool-cleaner-problems.html

Can an automatic pool cleaner (a polaris) cause a leak?




NDallasPun


I have an inground fiberglass pool and have been loosing about an inch of water a day. I read other answers and tried the bucket test and also marked the side of the pool with electrical tape to track.
I have noticed that my polaris has been shooting quite a bit of water out of the pool via splashing or getting stuck but the problem only began about a week and a half ago and I have had a polaris for years.
I completely shut the polaris off one morning before work just to test that theory. When I came home at the end of the day, the water level was fine! Then I turned the polaris on and after about an hour of running, the level dropped about a quarter of an inch.
I know water always flows through the polaris piping but could the surge in pressure after turning the polaris motor cause a minor crack to begin leaking?

Side note: my main drain line at the bottom of the pool has either clogged or collapsed but that has been the case for about a year and the pool has always looked crystal clear and maintained good water levels.
Any ideas or thoughts would be greatly appreciated! Thank you!



Answer
If the pool only leaks when the polaris pump is running it, it is almost certainly a break in the pipe between the booster pump and the pool. When the pump is running there is a lot mor pressure in the pipe so it will leak a lot quicker.
A leak detection company should be able to pin point where the leak is, and then a pool company can dig it up and fix it.

Look for wet soil in garden beds, etc. with the pump running.
Palm trees are the biggest culprit in breaking pool pipes.




Powered by Yahoo! Answers

Sabtu, 05 Oktober 2013

What happens if pesticide gets in a swimming pool?

automatic pool cleaner problems on Pool Cleaners - Pentair Pool Cleaners
automatic pool cleaner problems image



M W


A diluted amount of LAMBDA-CYHALOTHRIN got in my swimming pool. It is an over the counter pesticide to control ants, mosquitoes, beetles etc . A sudden wind gust drifted some of the pesticide in my swimming pool.


Answer
If it was a small amount and you are running a filter, it shouldn't be a problem. I would run the filter for at least 24 hours straight and brush the sides and bottom of the pool every few hours to stir up and remaining pesticide. If you have an automatic pool cleaner, you will also want to run it to help stir the water. You might also want to shock the pool.

Tail on Pentair Legend Pool Cleaner is shooting water all over whenever it makes a turn.?




Kimm


I have a Pentair Legend Pool cleaner. The tail constantly whips out of the water whenever it makes a turn and shoots water everywhere. It didn't used to do it so I know that something is not right. I'm tired of cleaning my windows :) Any ideas?


Answer
Two things to try:

1)There should be adjustment screw near tail attatchment point that controls the strength of tail water jet

2)there is a tail weight available from polaris pool cleaner tyhat will also fit on legend

more tips here: http://www.swimming-pool-information.com/automatic-pool-cleaner-problems.html




Powered by Yahoo! Answers