best automatic pool cleaner for the money image
russrimm
So I'm finally going to do it. I have wanted an in-ground gunite pool all my life. I had a couple of builders out to measure and due to utility easements and sewer lines, etc, I can only get about a 10' x 30', not sure how big that is really, still have to 'map it out' in the yard. So my questions are - what options should I get? Is the colored luminescent light worth it? I'm thinking of getting the salt-water chlorination system as well. What about 250,000 BTU vs 400,000 BTU for the hottub? Any kind of 'arc fountain' type things? What's worth it and what's not? Is Jandy or Hayward better for pump/filter/automatic pool vacuum? Would it be worth it for me to pay an extra $500+ to have my sewer line re-directed?
P.S. I'm in Houston, TX
Answer
It sounds like money isn't that impotent to you so go for your dreams.
I like the fiber optic lights they are very nice. Save your money on the heater & go with the cheaper one, onece it is heated eather will maintain it at that size. Most people don't buy a heater at all & the ones that do most of them dont run them because it cost to much & thay don't use the pool enough to make it worth while. The sewer I would think thay would rerout it for free if you suply the pipe & cupplers to be able to sell you a bigger pool(it wouldn't hurt to ask since thay have to dig it up to start with or just have them dig it up & you lay the pipe). Go with the best filter he sells that you are willing to pay up frount for it will save you in chems & services in the long run. I would also like to add if you have seen the frogs & turtles that hook to the jet & swim around & clean your pool you should get one(This is the auto pool vac). These seem very expencive for what they are but most people don't have the time or disaplin to clean there pool & this will help alot. You know with that green look or the dirt on the bottum that you keep saying you will take care of tomarrow. One last thing get a very good pool cover. This is the most inportent part aside from the water & just after chems.
Have fun & good luck.
It sounds like money isn't that impotent to you so go for your dreams.
I like the fiber optic lights they are very nice. Save your money on the heater & go with the cheaper one, onece it is heated eather will maintain it at that size. Most people don't buy a heater at all & the ones that do most of them dont run them because it cost to much & thay don't use the pool enough to make it worth while. The sewer I would think thay would rerout it for free if you suply the pipe & cupplers to be able to sell you a bigger pool(it wouldn't hurt to ask since thay have to dig it up to start with or just have them dig it up & you lay the pipe). Go with the best filter he sells that you are willing to pay up frount for it will save you in chems & services in the long run. I would also like to add if you have seen the frogs & turtles that hook to the jet & swim around & clean your pool you should get one(This is the auto pool vac). These seem very expencive for what they are but most people don't have the time or disaplin to clean there pool & this will help alot. You know with that green look or the dirt on the bottum that you keep saying you will take care of tomarrow. One last thing get a very good pool cover. This is the most inportent part aside from the water & just after chems.
Have fun & good luck.
What is the best automatic inground pool cleaner? What brand and price?
Francaise
Its a vinyl inground pool. Rectangular 18x36. Also budget is an issue, I am looking at spending $500 or less.
Answer
After 25 years of hearing how great floor head systems are, I have come to a conclusion. If your pool would have stayed looking nice with any cleaning system in your pool, it will stay nice with a floor head system.
If you plan on owning a pool for 5-6 years, or longer, in my opinion the best cleaning system(Dollar for Dollar) is a Polaris 280 with a booster pump and a separate time clock. The reasons are as follows:
1.)Low cost of repairs. I have clients with Polaris 180âs that are 25 years old. (The 280 has the same drive system.) Total repair costs in 25 years are less than $300.00 total (Not counting bag replacements.) I Personally, have owned a Polaris 280 for almost 5 years and have not spent a dime. (other than on 2 bags, and one of them was torn by my kids, and the other by a big pine cone. )
2.)It will clean most pools spotless in 10-20 minutes per day. You have seen our (5) 40â plus Ponderosa pines that overhang our pool area. Not counting steps and love seat, if we keep the bag cleaned, the floor stays spotless.
3.)Initial installation costs should be in the $1400.00-1600.00 range. Floor head systems are usually about double the initial expense. Also, the motor for the cleaning system is usually a 2 H.P. or larger, and the pool needs to run for substantially greater times to even get close to what a Polaris will do in ½ hour or less. Also, if you are not the initial purchaser of the system, you will not get a lifetime warrantee. Replacement gear systems, floor heads, ⦠can average more than $200.00 per year after the first 2 year, not to mention if the cleaner is not working correctly, i.e. heads jammed in the up position, actuator gears jammed, ⦠you are running that large motor with absolutely no cleaning going on. Any way you look at it, running a ¾ H.P. booster motor for 20-30 minutes is going to be a lot cheaper than running a 2 H.P. for 3-4 hours. Add into this that most motors run for more than 2 hours per day seem to have a life span in the 5-6 year range, and that a 2 H.P. motor is about double the cost, I cannot see spending the money.
4.)Suction side cleaners have a lower initial cost, but are annoying because either they will not pick up sticks, twigs, small rocks, ⦠or they will, and then they will completely stop working until you spend 10 minutes pulling them out and cleaning the debris out of them. Some of these will end up needing replacement parts just because of punctured diaphragms, ⦠This is in addition to an average annual repair cost of about $200-250, after the first year or two. In less than 5 years(More likely 3 years), if you add in electricity savings, pool cleanliness and thus chemical costs savings, and electrical savings, you have more than paid for the Polaris. If you add to this the fact that, if you have a suction side cleaner, you will have had to bring it in to the shop at least 4-5 times, having a non-functional cleaning system, thus a horridly dirty pool at least 4-5 times, the fact that often it dies a slow death each time so your pool doesnât look right for months prior to each rebuilding, and the repeated hassles of needing to unplug the system when ever any ârealâ debris ends up in the pool, and I wonât have anything else in my pool, or my families pools. To summarize, If you are buying a cleaner and are selling the home quickly, I would probably go with a pool Vac(if there are no rocks, sticks, big leaves, ⦠In other words, dirt only, but your annual repair costs will be high) or a Kreepy Krauley if you have anything else(Or want 40% less repair costs than the Pool Vac).
5.)Floor heads, or suction cleaners destroy the natural water flow around the pool which is responsible for moving the debris around to the skimmer on the surface, and for moving silt, and dirt to the main drain. Therefore, the surface areas of both sides of the pool(If the cleaners are functioning properly) will be an average of 20-40% dirtier than the same pool with a pool vac, return lines properly adjusted, and approximately ¾ of the suction of the pool going to the main drain. Also, since almost all of the suction for a suction side cleaner is directed to the cleaner, and thatâs run through an extra 30 feet or so of corrugated hose, the water flow is greatly reduced, and to get the same water filtration you will need to run that system approximately 25% -30% longer than a system without a suction cleaner. Thatâs 1 ¾ hrs longer running a 1 H.P. motor than is needed to run the ¾ H.P booster. Also, as a suction cleaner picks up debris, assuming it doesnât get plugged up and stop functioning all together, the baskets will fill up and all the suction to the pool will decrease or stop. There are times during the year where about 60% of the repair work I do is related to suction cleaning systems picking up too much debris. Note: This is never covered under any warrantee.
There is more that I could add, but I am too tired to do so now. Installation is as follows:
After 25 years of hearing how great floor head systems are, I have come to a conclusion. If your pool would have stayed looking nice with any cleaning system in your pool, it will stay nice with a floor head system.
If you plan on owning a pool for 5-6 years, or longer, in my opinion the best cleaning system(Dollar for Dollar) is a Polaris 280 with a booster pump and a separate time clock. The reasons are as follows:
1.)Low cost of repairs. I have clients with Polaris 180âs that are 25 years old. (The 280 has the same drive system.) Total repair costs in 25 years are less than $300.00 total (Not counting bag replacements.) I Personally, have owned a Polaris 280 for almost 5 years and have not spent a dime. (other than on 2 bags, and one of them was torn by my kids, and the other by a big pine cone. )
2.)It will clean most pools spotless in 10-20 minutes per day. You have seen our (5) 40â plus Ponderosa pines that overhang our pool area. Not counting steps and love seat, if we keep the bag cleaned, the floor stays spotless.
3.)Initial installation costs should be in the $1400.00-1600.00 range. Floor head systems are usually about double the initial expense. Also, the motor for the cleaning system is usually a 2 H.P. or larger, and the pool needs to run for substantially greater times to even get close to what a Polaris will do in ½ hour or less. Also, if you are not the initial purchaser of the system, you will not get a lifetime warrantee. Replacement gear systems, floor heads, ⦠can average more than $200.00 per year after the first 2 year, not to mention if the cleaner is not working correctly, i.e. heads jammed in the up position, actuator gears jammed, ⦠you are running that large motor with absolutely no cleaning going on. Any way you look at it, running a ¾ H.P. booster motor for 20-30 minutes is going to be a lot cheaper than running a 2 H.P. for 3-4 hours. Add into this that most motors run for more than 2 hours per day seem to have a life span in the 5-6 year range, and that a 2 H.P. motor is about double the cost, I cannot see spending the money.
4.)Suction side cleaners have a lower initial cost, but are annoying because either they will not pick up sticks, twigs, small rocks, ⦠or they will, and then they will completely stop working until you spend 10 minutes pulling them out and cleaning the debris out of them. Some of these will end up needing replacement parts just because of punctured diaphragms, ⦠This is in addition to an average annual repair cost of about $200-250, after the first year or two. In less than 5 years(More likely 3 years), if you add in electricity savings, pool cleanliness and thus chemical costs savings, and electrical savings, you have more than paid for the Polaris. If you add to this the fact that, if you have a suction side cleaner, you will have had to bring it in to the shop at least 4-5 times, having a non-functional cleaning system, thus a horridly dirty pool at least 4-5 times, the fact that often it dies a slow death each time so your pool doesnât look right for months prior to each rebuilding, and the repeated hassles of needing to unplug the system when ever any ârealâ debris ends up in the pool, and I wonât have anything else in my pool, or my families pools. To summarize, If you are buying a cleaner and are selling the home quickly, I would probably go with a pool Vac(if there are no rocks, sticks, big leaves, ⦠In other words, dirt only, but your annual repair costs will be high) or a Kreepy Krauley if you have anything else(Or want 40% less repair costs than the Pool Vac).
5.)Floor heads, or suction cleaners destroy the natural water flow around the pool which is responsible for moving the debris around to the skimmer on the surface, and for moving silt, and dirt to the main drain. Therefore, the surface areas of both sides of the pool(If the cleaners are functioning properly) will be an average of 20-40% dirtier than the same pool with a pool vac, return lines properly adjusted, and approximately ¾ of the suction of the pool going to the main drain. Also, since almost all of the suction for a suction side cleaner is directed to the cleaner, and thatâs run through an extra 30 feet or so of corrugated hose, the water flow is greatly reduced, and to get the same water filtration you will need to run that system approximately 25% -30% longer than a system without a suction cleaner. Thatâs 1 ¾ hrs longer running a 1 H.P. motor than is needed to run the ¾ H.P booster. Also, as a suction cleaner picks up debris, assuming it doesnât get plugged up and stop functioning all together, the baskets will fill up and all the suction to the pool will decrease or stop. There are times during the year where about 60% of the repair work I do is related to suction cleaning systems picking up too much debris. Note: This is never covered under any warrantee.
There is more that I could add, but I am too tired to do so now. Installation is as follows:
Powered by Yahoo! Answers
Tidak ada komentar:
Posting Komentar